RPS(Rail Pressure Sensor), consists of piezzo electric element, measures rail pressure inside of common rail.
ECM determines optimum fuel injection quantity at specific engine condition based on RPS signal. RPS signal is also used as rail pressure regualtor feed back signal in order to achieve optimum rail pressure at certain engine condition.
P0193 is set when RPS output voltage is above the maximum value of 4830mV(4.8V) for more than 0.2 sec.. This code is due to the open or short in 1) RPS signal circuit 2) RPS ground circuit.
Item | Detecting Condition | Possible Cause | ||
DTC Strategy | ● Voltage monitoring | ● RPS circuit ● RPS component | ||
Enable Conditions | ● Engine running | |||
Threshold Value | ● Output signal above the maximum value(above 4750mV) | |||
Diagnostic Time | ● 200ms | |||
Fail Safe | Fuel Cut | NO | ● Rail press. Sensor value fixed at 330bar | |
EGR Off | NO | |||
Fuel Limit | YES | |||
Check Lamp | YES | |||
