Visual Inspection of RPS
IG KEY "OFF", ENGINE "OFF".
Disconnect RPS connector.
Check if corrosion and damage in RPS terminal is detected.
Check RPS mounting torque and oil leakage.
Are the problems relevant to RPS found?
YES
Replace RPS if necessary and go to "Verification of Vehicle Repair".
NO
Go to "RPS waveform Inspection".
RPS Waveform Inspection
IG KEY "OFF", ENGINE "OFF".
Connect RPS connector.
Connect an Oscilloscope to RPS connector terminal 2.
After turning engine "ON", Check waveform at idle and during acceleration.
Specification : Refer to "Signal Waveform & Data" of "General Information".
Does RPS waveform look similar to standard "Signal Waveform & Data"?
YES
Go to "Verification of Vehicle Repair".
NO
Replace RPS and go to "Verification of Vehicle Repair".
