4.
Inspect opearating status of Motor with Actuation Test.
1)
Specification : It’s normal if operating sound is heard.
Connect scantool to Data Link Connector(DLC)
Ignition "ON" & Engine "OFF".
Select the "Actuation Test" mode on the scantool.
Inspect opearating status of Motor with Actuation Test.
Specification : It’s normal if operating sound is heard.
Does motor operate normally?
YES
Fault is intermittent caused by poor connection in motor circuit or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
Go to "Terminal and Connector Inspection" procedure.
