4.
Monitor the "WHEEL SPD SNSOR" parameter on the Scantool.
1)
Specification : Specification : Compare with another parameters related to wheel speed sensor.
If it is the same as another parameters, it is in normal condition.
Ignition "ON" & Engine "ON".
Connect scantool to Data Link Connector(DLC).
Start and drive vehicle in gear and maintain vehicle speed at or above 50km/h. (31mph)
Monitor the "WHEEL SPD SNSOR" parameter on the Scantool.
Specification : Specification : Compare with another parameters related to wheel speed sensor.
If it is the same as another parameters, it is in normal condition.
Is parameter displayed within specifications?
YES
Fault is intermittent caused by poor connection in wheel speed sensor harness, Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Repair as necessary and then go to "Verification of vehicle Repair" procedure.
NO
Go to "Component Inspection" Procedure.
