Monitor Scantool Data
1.

Connect scantool to Data Link Connector(DLC).

2.

Engine "ON".

3.

Turn the steering wheel to the left or right.

4.

Monitor the "steering sensor" parameters on the Scantool.

5.

Whenever steering wheel is turned, is the steering sensor’s scantool data changed?

YES

a.

1) Connect scantool to Data Link Connector(DLC).

2) Ignition "ON" & Engine "ON".

3) Keep the steering wheel in ceter position.

4) Monitor the "STEERING ANGLE SNSR" parameters on the Scantool.

5) Is parameter displayed within specifications?

■YES

→ Go to "Terminal and Connector Inspection" procedure.

■NO

→ Go to next step.

b.

Go to "Terminal and Connector Inspection" procedure.

6.

Perform steering angle sensor calibration.

(1)

Ignition "ON" & Engine "OFF".

(2)

Line up the steering wheel in a straight.

(3)

Connect scantool to Data Link Connector(DLC).

(4)

Go in Elec. Power Steering system. (figure 3).

(5)

Perform ASP calibration. (figure 4).

(6)

Go to "Compnent Inspection" Precedure.

Яндекс.Метрика