Component Location
General Description

The purpose of the System Voltage is to detect an excessively low or high system voltage that may be caused by a malfunctioning charging system..

System Voltage is the ignition voltage potential at the Powertrain Control Module (PCM) PCM measures and compares voltage from ignition key and each relay. With this mechanism, PCM knows if the main relay switch turns on after IG on or if turns OFF after IG off.

DTC Description

If the system voltage is below 2.54V during 0.2 sec, PCM sets DTC P0561.

DTC Detecting Condition

Item

Detecting Condition

Possible Cause

DTC Strategy

● Input signal check

● Poor connection

● Open/short to ground in control circuit

● Charging system

● Main relay

Enable Conditions

Threshold Value

● Voltage < 2.54 V

Diagnostic Time

● 0.2 sec

MIL ON Condition

● 2 driving cycle

Schematic Diagram
note
To view Flash content, you need to install the appropriate browser extension
Яндекс.Метрика