3.
Has a problem been found?
YES
a.
Repair as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
a.
Go to "Control Circuit open Inspection" procedure.
Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
YES
Repair as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
Go to "Control Circuit open Inspection" procedure.
Ignition "OFF".
Disconnect the battery (+) & (-) terminal cable from the battery and wait at least one minutes.
Disconnect PAB SWITCH connector and SRSCM main harness connector.
Measure resistance between terminal "1" of the PAB SWITCH harness connector and chassis ground.
Specification : ∞
Is the measured resistance within specifications?
YES
After checking connecting condition and short to ground from PAB SWITCH harness to SRSCM harness, repair or replace it if needed and go to "Verification and Vehicle Repair".
Go to "Component Inspection".
NO
After replacing harness and go to "Verification and Vehicle Repair".
