1.
Remove the reservoir hose (A), disconnect the swirl valve actuator connector (B).
Remove the reservoir hose (A), disconnect the swirl valve actuator connector (B).
Remove the intercooler hose (A) and the throttle body (B). For the vehicles equipped with the Catalyzed Particulate Filter (CPF), remove the air heater (C) after removing the electrical throttle control assembly (D) by disconnecting its connector (E).
Remove the EGR cooler pipe (A).
Tightening torque :
Nut (B) : 14.7 ~ 19.6N.m (1.5 ~ 2.0kgf.m, 10.8 ~ 14.5lb-ft)
Disconnect the throttle flap control solenoid connector (A) and VGT solenoid valve connector (B) and remove the bracket. For the vehicles equipped with the Catalyzed Particulate Filter (CPF), there is no throttle flap control solenoid but VGT solenoid only.
Disconnect the fuel return hose (A), the high pressure pipe (B) and the fuel temperature sensor mounting.
Remove the intake manifold.
Tightening torque :
14.7 ~ 19.6N.m (1.5 ~ 2.0kgf.m, 10.8 ~ 14.5lb-ft)
Remove the intake manifold gasket (A).
Installation is in the reverse order of removal.
