13150107

Replacement

caution

●

After replacing ECM, MUST input the injector specific data (7 digits) of each cylinder into a new ECM with scan tool.

●

In the case of the vehicle equipped with immobilizer, perform "Key Teaching" procedure together (Refer to "Immobilizer" in BE group).

Turn ignition switch OFF and disconnect the negative (-) battery cable.

Disconnect the ECM connector (A).

Unscrew the ECM mounting bolts (B) and remove the ECM.

Install a new ECM.

ECM installation bolts:

7.8 ~ 11.8 N·m (0.8 ~ 1.2 kgf·m, 5.8 ~ 8.7 lbf·ft)

Connect the negative(-) battery cable.

Perform "ECM Change" procedure [With CPF].

(1)

Turn ignition switch OFF.

(2)

Connect a GDS Data Link Connector (DLC).

(3)

Turn ignition switch ON.

(4)

Select "Vehicle, Model year, Engine, System".

(5)

Select "Vehicle S/W Management".

(6)

Select "Component Change Routine".

(7)

Select "ECU Change".

(8)

Input the mileage in odometer.

(9)

Confirm the "Complete" message and then turn ignition switch OFF.

(10)

Wait for more than 10 seconds, and then turn ignition switch ON.

Perform "Injector Specific Data Input" procedure (Refer to "Injector" in this group).

Perform "Key Teaching" procedure (Refer to "Immobilizer" in BE group).