3.
Are any DTCs present ?
▶ Go to the applicable troubleshooting procedure.
▶ System is performing to specification at this time.
If there is(are) DTC(s) of auto-transmission, ECM sets DTC P0700. In this case, check DTC(s) of auto-transmission and repair it.
Item | Detecting Condition | Possible Cause |
DTC Strategy | ● Signal interference | ● Poor connection ● TCM ● ECM |
Enable Conditions | ||
Threshold Value | ● When TCM demands | |
Diagnostic Time |
Connect scantool to Data Link Connector(DLC).
Warm up the engine to normal operating temperature.
Monitor A/T DTC(Diagnostics Trouble Code) on the scantool.
Then refer to "Automatic-Transmission's DTC Guide".
After a repair, it is essential to verify that the fault has been corrected.
Connect scan tool and select "Diagnostic Trouble Codes(DTCs)" mode.
Clear the DTCs and Operate the vehicle within DTC Enable conditions in General information.
Are any DTCs present ?
▶ Go to the applicable troubleshooting procedure.
▶ System is performing to specification at this time.
