2.
Connect the Hi-Scan Pro connector to the data link connector located under the crash pad.
Turn the ignition switch off.
Connect the Hi-Scan Pro connector to the data link connector located under the crash pad.
Turn the ignition switch on and power on the Hi-Scan Pro.
Read DTCs.
Find and repair the trouble, and clear the DTCs using Hi-Scan Pro.
Disconnect the Hi-Scan Pro.
Confirm proper system operation :
Turn the ignition switch ON ; the SRS indicator light should be turned on for about six seconds and then to off.
After a repair, it is essential to verify that the fault has been corrected.
Connect scantool and select "Diagnostic Trouble Codes(DTC)" mode.
Using a scantool, clear the DTC.
Operate the vehicle within DTC Enable conditions in General information.
Are any DTC present ?
▶ Go to the applicable troubleshooting procedure.
▶ System is performing to specification at this time.
