Ignition "OFF"

Disconnect the connector of temperature control actuator.

Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 3 and grounding terminal 4.

Verify that the temperature control actuator operates to the cool position when connecting in the reverse.

Check the voltage between terminals 5 and 6.

* It will feedback current position of actuator to controls.

If the measured voltage is not specification, substitute with a known-good temperature control actuator and check for proper operation.

If the problem is corrected, replace the temperature control actuator.

Check the voltage between terminals 5 and 6.

* It will feedback current position of actuator to controls.

If the measured voltage is not specification, substitute with a known-good temperature control actuator and check for proper operation.

If the problem is corrected, replace the temperature control actuator.

Disconnect the negative (-) battery terminal.

Remove the crush pad lower panel (A).

Disconnect the damper (B) from the glove box (A).

Remove the crash pad lower panel (A).

Remove the sower duct (A).

Disconnect the temperature control actuator connector (A).

Loosen the mounting screw and then remove the temperature control actuator (B).

Remove the driver's crush pad lower panel (A).

(Refer to BD group - "Crash pad")

After loosening the mounting bolts, then remove the reinforcing panel (A).

Disconnect the mode control actuator connector (A) after removing the air duct.

Loosen the mounting screws and then remove the mode control actuator (B).

Installation is the reverse order of removal.