2.
Separate the cluster facia panel (B) from the crash pad pulling the SST (09840-1E100) (A).
When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Tilt the steering column down.
Separate the cluster facia panel (B) from the crash pad pulling the SST (09840-1E100) (A).
After loosening the mounting screws, then remove the cluster fascia (A).
Disconnect the connector (A).
Installation is the reverse the removal.
Make sure the connector is plugged in properly.
When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Put the SST (09840-1E100) (A) into the space between the center fascia and crash pad.
Be care not to damage the center facia and crash pad.
Separate the center facia panel from the crash pad pulling the SST (09840-1E100) (A) as shown on the photo.
Pull the SST (09840-1E100) (A) slowly not to damage the center fascia panel.
Pull the other side of center facia panel with the SST (09840-1E100) in the way of "step 2)".
After loosening the mounting clips, then remove the center facia lower tray (A).
Installation is the reverse of removal.
Remove the crash pad side cover.
Disconnecting the connector (B).
After loosening the crash pad lower panel mounting screws, then remove the lower panel (A).
After loosening the mounting bolts, then remove the reinforcing panel (A).
Installation is the reverse of removal.
Remove the center facia panel .
After loosening the mounting screws, then remove the audio assembly (A).
Disconnect the connector (A).
Installation is the reverse of removal.
Make sure the connector is plugged in properly.
Disconnect the damper (B) from the glove box (A).
Remove the glove box (A) from the lift (B).
Disconnect the pine (A), then remove the glove box (B).
After loosening the mounting screws, then remove the glove box housing (A).
Disconnect teh connector (B).
Installation is the reverse of removal.
Loosen the screws.
Remove the shroud assembly (A).
Installation is the reverse of removal.
When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Remove the crash pad side cover (A).
Installation is the reverse of removal.
When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Remove the following items.
Front seat.
Cluster fascia panel, cluster.
Audio assembly.
Glove box.
Crash pad side cover.
Front pillar trim.
Remove the photo sensor.
Disconnect the passenger`s air bag connector (A).
Loosen the bolts and nuts, then remove the crash pad (B).
Installation is the reverse of removal.
Make sure the crash pad fits onto the guide pins correctly.
Before tightening the bolts, make sure the crash pad wire harnesses are not pinched.
Make sure the connectors are plugged in properly, and the antenna lead is connected properly.
Enter the anti- theft code for the radio, then enter the customer`s radio station presets.
