13157891

1.

Turn the ignition switch to OFF.

2.

Connect the Hi-scan tool to the DLC connector for diagnosis.

3.

Turn the ignition switch to ON.

4.

Check the diagnostic trouble codes using the Hi-scan tool.

5.

Read the output diagnostic trouble codes. Then follow the remedy procedures according to the "DIAGNOSTIC TROUBLE CODE DESCRIPTION" on the following pages.

note

●

A maximum of 5 diagnostic trouble codes (in the sequence of occurrence) can be stored in the Random Access Memory (RAM) incorporated within the control module.

●

The same diagnostic trouble code can be stored one time only.

●

If the number of stored diagnostic trouble codes or diagnostic trouble patterns exceeds 5, already stored diagnostic trouble codes will be erased in sequence, beginning with the oldest.

●

Do not disconnect the battery until all diagnostic trouble codes or diagnostic trouble patterns have been read out, because all stored diagnostic trouble codes or diagnostic trouble patterns will be cancelled when the battery is disconnected.

●

All diagnostic trouble codes are deleted from memory the 200th time the ATF temperature reaches 50°C(122°F) after memorization of the most recent diagnostic code.

6.

Delete the diagnostic trouble code.

7.

Disconnect the Hi-scan tool.

note

DTC cleaning should only be done with the scan tool.

No.	Code	Item	MIL	Remark
1	P0605	Internal Control Module Read Only Memory(ROM) Error	●
2	P0707	TRANSAXLE RANGE SWITCH CIRCUIT LOW INPUT	●
3	P0708	TRANSAXLE RANGE SWITCH CIRCUIT HIGH INPUT	●
4	P0711	TRANSAXLE FLUID TEMPERATURE SENSOR RATIONALITY	●
5	P0712	TRANSAXLE FLUID TEMPERATURE SENSOR CIRCUIT LOW INPUT	●
6	P0713	TRANSAXLE FLUID TEMPERATURE SENSOR CIRCUIT HIGH INPUT	●
7	P0716	A/T INPUT SPEED SENSOR RATIONALITY	●
8	P0717	A/T INPUT SPEED SENSOR CIRCUIT - OPEN or SHORT(GND)	●
9	P0722	A/T OUTPUT SPEED SENSOR CIRCUIT - OPEN or SHORT(GND)	●
10	P0731	GEAR 1 INCORRECT RATIO	●
11	P0732	GEAR 2 INCORRECT RATIO	●
12	P0733	GEAR 3 INCORRECT RATIO	●
13	P0734	GEAR 4 INCORRECT RATIO	●
14	P0741	TORQUE CONVERTER CLUTCH STUCK OFF	●
15	P0742	TORQUE CONVERTER CLUTCH STUCK ON	●
16	P0743	TORQUE CONVERTER CLUTCH CONTROL SOLENOID VALVE - OPEN or SHORT(GND)	●
17	P0748	VFS SOLENOID VALVE CIRCUIT - OPEN or SHORT(GND)	X
18	P0750	ON/OFF(SCSV-A) SOLENOID VALVE CIRCUIT - OPEN or SHORT(GND)	●
19	P0755	PCSV-A(OD＆LR ) SOLENOID VALVE CIRCUIT - OPEN or SHORT(GND)	●
20	P0760	PCSV-B(2-4 SOLENOID VALVE) CIRCUIT - OPEN or SHORT(GND)	●
21	P0765	PCSV-C(UD) SOLENOID VALVE CIRCUIT - OPEN or SHORT(GND)	●
22	P0880	TCM POWER SIGNAL ERROR	●
23	U0001	CAN BUS OFF	●
24	U0100	CAN TIME OUT	●