6501285

Component Inspection

■ Clutch switch Check

Ignition "OFF" & Engine "OFF".

Disconnect the clutch switch connector.

Measure resistance between signal terminal and ground terminal of the clutch switch connector.

Specification : Approx. below 1Ω - (In case of pressing the clutch switch)

Approx. ∞ Ω - (In case of not pressing the clutch switch)

Is the measured value within specifications?

	▶ Fault is intermittent caused by poor connection in clutch switch harness and/or HECU's connector.Go to "Verification of Vehicle Repair" procedure.
	▶ Substitute with a known-good clutch switch and check for proper operation. If problem is corrected, replace clutch switch and then go to "Verification of Vehicle Repair" procedure.