6507191

1.

Ignition "OFF".

2.

Ignition "ON" & Engine "OFF".

3.

Connect scantool and select "Diagnostic Trouble Codes(DTCs)" mode

4.

Using a scantool, Clear DTC.

5.

Operate the vehicle within DTC Detecting Condition in General Information. (turn right and left at least 1 time)

6.

Select "Diagnostic Trouble Codes(DTCs)" mode again.

7.

Are any DTCs present ?

	▶ Substitute with a known-good steering column & EPS unit assembly check for proper operation. If problem is corrected, replace steering column & EPS unit assembly and then go to "Verification of Vehicle Repair" procedure.
	▶ Fault is intermittent caused by faulty EPS CM or was repaired and EPS CM memory was not cleared. go to "Verification of Vehicle Repair" procedure.