5.
Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.
note
-
Make sure that there is no air leaking out of the blower and duct joints.
Disconnect the negative (-) battery terminal.
Remove the crash pad.
(Refer to BD group - Crash pad)
Disconnect the connectors from the intake actuator, the blower motor and power mosfet.
Remove the cowl cross bar assembly.
(Refer to BD group - Crash pad)
Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.
Make sure that there is no air leaking out of the blower and duct joints.
Installation is the reverse order of removal.
