1.
Apply gear oil on the oil seal contacting surface (B) of transaxle case and the driveshaft splines (A).
caution
●
Replace circlip with new one.
●
Be careful not to install a different kind, when replacing the circlip.
Apply gear oil on the oil seal contacting surface (B) of transaxle case and the driveshaft splines (A).
Replace circlip with new one.
Be careful not to install a different kind, when replacing the circlip.
Before installing the driveshaft (C), set the opening side of the circlip (D) facing downward.
After installation, check that the driveshaft (C) cannot be removed by hand.
Install the driveshaft (A) to the axle hub (B).
Be careful not to damage and dent the both boots.
Keep clean without contamination on contacting point between the hub-bearingand BJ.
Install the ball joint assembly mounting nut (A) to the knuckle.
Tightening torque Nm (kgf.m, lb-ft) :
98.1~117.7 (10~12, 72.3~86.8)
Install the washer (C), castle nut (B) and split pin (A) to the front hub assembly.
Tightening torque Nm (kgf.m, lb-ft) :
196.1~274.6 (20~28, 144.7~202.5)
The washer (C) should be assembled with convex surface outward when installing the castle nut (B) and split pin (A).
Install the wheel and the tire to the front hub.
Tightening torque Nm (kgf.m, lb-ft) :
88.3~107.9 (9~11, 65.1~79.6)
Be careful not to damage the hub bolts when installing the front wheel and tire.
