3.
Remove the rear wheel and tire from rear hub.
caution
Be careful not to damage to the hub bolts when removing the rear wheel and tire.
Release the parking brake.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
Remove the rear wheel and tire from rear hub.
Be careful not to damage to the hub bolts when removing the rear wheel and tire.
Remove the mounting bolt (B) of the rear lower arm (A) and the rear carrier, while supporting the lower arm (A) with a jack as shown in the illustration.
Be careful not to damage the deadener coating
Loosen the mounting nut (A) of the cross member and the rear lower arm, then remove the coil spring (B) by taking down the jack.
Remove the wheel speed sensor (A) and parking brake cable (B).
Disconnect the upper arm (B) from the carrier assembly after loosen the nut (A).
Remove the brake caliper mounting bolts (A), and then place the brake caliper assembly (B) with wire as shown in the illustration.
Remove the rear brake disc assembly (A) after loosen the screw (B).
Remove the rear shock absorber assembly (C) after loosen the bolt (A, B).
Remove the split pin and castle nut from the assist arm.
Using the SST (09568-4A000), disconnect the assist arm (A) from the carrier assembly.
Remove the carrier assembly (A) from the trailing arm after remove the mounting bolts.
Remove the rear hub assembly (C) and rear brake assembly (B) after remove mounting bolts (A).
