1.
Install the rear hub assembly (C) and rear brake assembly (B) to the rear carrier, then tighten mounting bolts (A).
Tightening torque Nm (kgf.m, lb-ft) :
58.8~68.6 (6.0~7.0, 43.4~50.6)
Install the rear hub assembly (C) and rear brake assembly (B) to the rear carrier, then tighten mounting bolts (A).
Tightening torque Nm (kgf.m, lb-ft) :
58.8~68.6 (6.0~7.0, 43.4~50.6)
Install the carrier assembly (A) to the trailing arm, then tighten the mounting bolts.
Tightening torque Nm (kgf.m, lb-ft) :
34.3~53.9 (3.5~5.5, 25.3~39.8)
Install the assist arm(B) to the carrier assembly (A) , then install the castle nut and split pin.
Tightening torque Nm (kgf.m, lb-ft) :
44.1~53.9 (4.5~5.5, 32.5~39.8)
Install the rear strut assembly (C), then tighten the bolt (A, B).
Tightening torque Nm (kgf.m, lb-ft) :
Bolt(A) : 49.0~63.7 (5.0~6.5, 36.2~47.0)
Bolt(B) : 137.3~156.9 (14.0~16.0, 101.3~115.7)
Install the rear brake disc assembly (A) and tighten screw (B).
Install the brake caliper, then tighten the brake caliper mounting bolts (A).
Tightening torque Nm (kgf.m, lb-ft) :
49.0~58.8 (5.0~6.0, 36.2~43.4)
Install the upper arm (B) from the carrier assembly , then tighten the nut (A).
Tightening torque Nm (kgf.m, lb-ft) :
Nut(A) : 98.1~117.7 (10~12, 72.3~86.8)
Install the wheel speed sensor (A) and parking brake cable (B).
Install the coil spring (A) on the rear lower arm (B), then slowly jack-up the rear lower arm (B) by using jack.
Install the mounting bolt (B) of the rear lower arm (A) and the rear carrier with a specified torque, while supporting the lower arm (A) with a jack as shown in the illustration. Tighten the mounting bolt (C) of the cross member and the rear lower arm with a specified torque.
Tightening torque Nm (kgf.m, lb-ft) :
Bolt (B, C) :137.3~156.9 (14.0~16.0, 101.3~115.7)
Install the wheel and the tire to the rear hub.
Tightening torque Nm (kgf.m, lb-ft) :
88.3~107.9 (9~11, 65.1~79.6)
Be careful not to damage the hub bolts when installing the rear wheel and tire.
