2.
Remove the snap pin (A) and the select cable (B).
Remove the floor console assembly.
(Refer to "Interior(Console)" in BD group)
Remove the snap pin (A) and the select cable (B).
Remove the shift lever assembly (B) after removing shift lever assembly mounting bolts (A).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Remove the pin (A) after disconnect the shift cable (B).
Remove the boots (A) and knob (B) from the lever assembly by rotating counter-clockwise.
Installation is the reverse of removal.
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Remove the floor console assembly.
(Refer to "Interior(Console)" in BD group)
Remove the snap pin (A) and select cable assembly (B).
Remove the shift lever assembly (B) after removing shift lever assembly mounting bolts (A).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Remove the pin(A) after disconnect the shift cable (B).
Remove the retainer (A) and nut (B).
Tightening torque:
11.7 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.6 ~ 10.8 lb-ft)
Remove the shift & select cable (B) after removing the snap pins (A) from the engine room side.
Remove the shift cable and select cable at cabin room.
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
