Removal
PARKING BRAKE LEVER
note

The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.

1.

Remove the floor console. (Refer to BD Gr. -"Floor console")

2.

Loosen the adjusting nut (A) and the parking brake cables.

3.

Disconnect the connector (A) of parking brake switch.

4.

Remove the parking brake lever assembly (A) with loosening the bolts.

PARKING BRAKE SHOE (DISC BRAKE TYPE)
1.

Raise the vehicle, and make sure it is securely supported.

2.

Remove the rear tire and wheel, then remove the brake caliper. (Refer to "Rear disc brake removal")

3.

Remove the parking brake cable (B), after remove the clip (A).

4.

Remove the shoe hold down pin (A) and spring (B) by pressing and rotating the spring.

5.

Remove the adjuster assembly (B) and the lower return spring (A).

6.

Remove the upper return spring (C) and the brake shoes (D).

7.

Remove the operating lever assembly (E).

Яндекс.Метрика