Install the steering gear box (A) to the sub frame by tightening the mounting bolts.
Tightening torque Nm (kgf.m, lb-ft):
60 ~ 80 (6.0 ~ 8.0, 43 ~ 58)
Install the rear roll stopper (A) to the sub frame by tightening the mounting bolts.
Tightening torque Nm (kgf.m, lb-ft):
50 ~ 65 (5.0 ~ 6.5, 36 ~ 47)
Install the sub frame (E) and sub frame stay by tightening the mounting bolts (A, C) and nuts (B, D).
Tightening torque Nm (kgf.m, lb-ft)
Sub frame mounting bolts (C) and nuts (D):
160 ~ 180 (16.0 ~ 18.0, 116 ~ 130)
Sub frame stay mounting bolt (A) and nut (B):
45 ~ 55 (4.5 ~ 5.5, 33 ~ 40)
Tighten the front and rear roll stopper bolt and nut (A, B).
Tightening torque Nm (kgf.m, lb-ft):
50 ~ 65 (5.0 ~ 6.5, 36 ~ 47)
Install the wiring harness protector to the sub-frame by tightening the bolts (A).
Install the muffler rubber hanger (A).
Connect the lower arm with the ball joint and then remove the castle nut and the split pin.
Connect the tie rod end with the knuckle and then install the castle nut and split pin.
Tightening torque Nm (kgf.m, lb-ft):
24 ~ 34 (2.4 ~3.4, 17 ~ 25)
Connect the stabilizer link (A) with the front strut assembly and than tighten the nut.
Tightening torque Nm (kgf.m, lb-ft):
100 ~ 120 (10.0 ~ 12.0, 72 ~ 87)
Connect the universal joint assembly (B) with the pinion of the steering gear box and then tighten the bolt (A).
Tightening torque Nm (kgf.m, lb-ft):
30 ~ 35 (3.0 ~ 3.5, 22 ~ 25)
Tighten up with bolt after inserting U-joint to the steering gear pinion shaft firmly.
Install the front wheel & tire.
Tightening torque Nm (kgf.m, lb-ft):
90 ~ 110 (9.0 ~ 11.0, 65 ~ 80)
Check and adjust the front wheel alignment. (Refer to SS group)
Perform the ASP (Absoulte Steering Position) calibration procedure. (Refer to ASP calibration)
If the ASP calibration procedure is not performed, EPS warning lamp will be turned on or flicker and behicle may pull to the left or the right.