With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch
With the multi function switch in each position, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.
Disconnect the negative (-) battery terminal.
Remove the steering column upper and lower shrouds after removing 3 screws.
Remove the 2 screws (A,B) after turning the steering left and right.
Disconnect the light switch connector (A) and the wiper switch connector (B).
Remove the wiper switch (A) by releasing the lock (B).
when removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.
Remove the clock spring(A).
Loosen the screws from the multifunction switch assembly (A).
Remove the multifunction switch assembly after loosening the connectors.
Install the wiper switch then connect the lighting switch connector.
Install the lighting switch then connect the wiper switch connector.
Install the steering column upper and lower shrouds.
