2.
Pull out the relay from the engine compartment relay box.
A : Head lamp(Low) relay
B : Head lamp (High) relay
Disconnect the negative(-) battery terminal.
Pull out the relay from the engine compartment relay box.
A : Head lamp(Low) relay
B : Head lamp (High) relay
Check for continuity between terminals. There should be continuity between the No.87 and No.30 terminals when power and ground are connected to the No.86 and No.85 terminals.
There should be no continuity between the No.87 and No.30 terminals when power is disconnected.
Disconnect the negative(-) battery terminal.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
Remove the junction box.
Check for continuity between the terminals.
There should be continuity between the No.2 terminal in the I/P-H and the No.15(LH) or 4(RH) terminal in the I/P-G when power and ground are connected to the No.2 terminal in the I/P-H and the No.6 terminal in the I/P-D.
There should be no continuity between the No.2 terminal in the I/P-H and the No.15(LH) or 4(RH) terminal in the I/P-G when power and ground are connected to the No.2 terminal in the I/P-H and the No.6 terminal in the I/P-D.
If Head Lamp is lighting by Head Lamp SW or AUTOLIGHT, Head Lamp lighting is maintained when IGN1 is changed ON to OFF.
Following stste, Head Lamp lighting is truned off.
But, TAIL LAMP keep up lighting when KEY IN in the condition of lighting off after IGN ON→OFF and lighting.
(the condition of TAIL LAMP lighting off follows TAIL LAMP AUTOCUT function.)
When Driver DOOR SW OPEN→CLOSE and after 30sec.
When Head Lamp SW ON or not the case of AUTO LIGHT SW ON.
(ALC ; When Head Lamp ON, Head Lamp SW ON within Multi-function SW during ESCORT → Lighting keeping up when SW is moned to AUTO LIGHT SW ON or reverse.)
When Driver DOOR OPEN state is maintained after 5minute.
When IGN1 ON→IGN OFF and sfter 5minute.
When received TX LOCK signal two times during output.
Head Lamp RELAY output of TIMING CHART contains the condition of TAIL LAMP ON.
Head Lamp RELAY output by - Head Lamp SW and HEAD LAMP RELAY output by AUTO LIGHT is regarded identical condition.
That is, the explaining of HEAD LAMP RELAY ouput contains two cases.
AUTO LIGHT SW ON : HEAD LAMP＆TAIL LAMP signal by AUTO LIGHT is output.
AUTO LIGHT SW OFF: HEAD LAMP＆TAIL LAMP signal by AUTO LIGHT is not output.
