Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least three minutes.
Connect the Seat Belt Pretensioner (BPT) connector.
Install the Seat Belt Pretensioner (BPT) with a bolt.
Install the upper anchor bolts.
Tightening torque (Seat Belt Anchor Bolt)
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9 ~ 39.8 lb.ft)
Install the center pillar trim.
Install the door scuff trim.
Install the lower anchor bolts.
Tightening torque
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9 ~ 39.8 lb.ft)
Reconnect the battery negative cable.
After installing the Seat Belt Pretensioner (BPT), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
