Disconnect the negative (-) battery terminal.

Remove the crush pad lower panel (A).

Disconnect the damper (B) from the glove box (A).

Remove the crash pad lower panel (A).

Remove the sower duct (A).

Disconnect the temperature control actuator connector (A).

Loosen the mounting screw and then remove the temperature control actuator (B).

Remove the driver's crush pad lower panel (A).

(Refer to BD group - "Crash pad")

After loosening the mounting bolts, then remove the reinforcing panel (A).

Disconnect the mode control actuator connector (A) after removing the air duct.

Loosen the mounting screws and then remove the mode control actuator (B).

Installation is the reverse order of removal.