1.
Remove the quadrant inner cover (A).
Take care not to scratch the door trim and other parts.
Put on gloves to protect your hands.
Remove the quadrant inner cover (A).
Loosen the door trim (A) mounting screws. Release the clips that hold the door trim, then remove the door trim by pulling it upward. Disconnect the power window switch connector, power mirror connector, and door courtesy lamp connector, trunk lid connector.
Disconnect the cable (A).
Installation is the reverse of removal.
Make sure of connectors is plugged in properly and each rod is connected securely.
Make sure the door lock and opens properly.
Remove the door trim.
Loosen the door inside handle mounting screws, remove the door inside handle (A).
Installation is the reverse of removal.
Remove the front door trim.
Remove the glass mounting hole plug (B).
Using the door switch to align the mounting hole with the hole on the door glass.
If it is impossible, align the hole with hands after removing the motor.
Take care not to drop to glass and scratch the glass surface.
Carefully move the glass (A) until you can see thebolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Installation is the reverse of removal.
Roll the glass up down to see if it move freely without binding.
Adjust the position of the glass as necessary.
Remove the door trim.
Drill out the rivets to remove the speaker (B) from the door module.
Disconnect the speaker connector (A).
Installation is the reverse of removal.
Use sheet metal screws to secure the speaker.
Remove the door trim .
After disconnecting the connector (A), remove the power window motor (B).
Installation is the reverse of removal.
The area of rotational parts and springs should be applied with sufficient grease.
Roll the glass up down to see if it move freely without binding.
Remove the following parts.
Door trim.
Glass.
Outside handle.
Loosen the mounting screw (A).
Loosen the door module mounting bolts, then remove the door module (A).
Disconnect the connector (A).
Disconnect the door module wiring harness (B), then remove the module assembly (C).
Installation is the reverse of removal.
The area of whole parts should be applied with sufficient grease.
Make sure the connector is plugged in properly and each rod is connected securely.
Make sure the door lock and open properly.
After loosening the mounting bolt, then remove the key holder (A).
Remove the outside handle (A) by sliding it rearward.
Remove the outside handle pad (A).
Installation is the reverse of removal.
Make sure the door lock and open properly
Loosen the checker mounting bolts.
Detach the clips, then remove the weatherstrip(A).
Installation is the reverse of removal.
