1.
Remove the delta inner cover (A).
Take care not to scratch the door trim and other parts.
Put on gloves to protect your hands.
Remove the delta inner cover (A).
Loosen the door trim (A) mounting screws. release the clips that hold the door trim, then remove the door trim by pulling it upward. disconnect the power window switch connector.
Disconnect the lock cable and (A) inside connect cable (B).
Installation is the reverse of removal.
Make sure of connectors is plugged in properly and each rod is connected securely.
Make sure the door lock and opens properly.
Remove the door trim.
Loosen the door inside handle mounting screws, remove the door inside handle (A).
Installation is the reverse of removal.
Put on gloves to protect your hands.
Remove the door trim.
Remove the door belt weatherstrip.
Release the rear channel mounting bolt and nut.
Take care not to drop to glass and scratch the glasssurface.
Carefully move the glass (A) until you can see thebolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Installation is the reverse of removal.
Roll the glass up down to see if it move freely without binding.
Adjust the position of the glass as necessary.
Remove the door trim.
Drill out the rivets to remove the speaker (B) from the door module.
Disconnect the speaker connector (A).
Installation is the reverse of removal.
Use sheet metal screws to secure the speaker.
Remove the door trim.
After disconnecting the connector (A), remove the power window motor (B).
Installation is the reverse of removal.
The area of rotational parts and springs should be applied with sufficient grease.
Roll the glass up down to see if it move freely without binding.
After loosening the mounting bolt, then remove the handle cover (A).
Remove the outside handle (A) by sliding it rearward.
Remove the outside handle pad (A).
Installation is the reverse of removal.
Make sure the door lock and open properly.
Remove the following parts.
Door trim.
Window glass.
Outside handle.
Loosen the mounting screw (A).
Remove the rear channel (A).
After loosening the door module mounting bolts, remove the door module (A).
Disconnect the connector (B).
Detach the clips, then remove the wiring harness(C).
Installation is the reverse of removal.
The area of whole parts should be applied with sufficient grease.
Make sure the connector is plugged in properly and each rod is connected securely.
Make sure the door lock and open properly.
Loosen the checker mounting bolts.
Detach the clips, then remove the weatherstrip(A).
Installation is the reverse the removal.
