7.
In a case of getting out of specification( 478±10mm ), Repeat from procedure No.3 to procedure No.5, again.
Make a vehicle's level to normal level.
After IG "OFF", connect scantool to Data Link Connector(DLC) and then, IG "ON"
Charge the air into the reservoir tank by Reservoir filling program.
Operate "Height sensor calibration" program.
Using a tape-measure, Enter the actual height into the scantool.
Compare the current height of scantool with the actual height.
In a case of getting out of specification( 478±10mm ), Repeat from procedure No.3 to procedure No.5, again.
Is the height sensor's calibration completed?
 | ▶ Go to "Verification of Vehicle Repair" procedure. |
 | ▶ Substitute with a known-good ALS ECU and check for proper operation. If problem is corrected, replace ALS ECU and then go to "Verification of Vehicle Repair" procedure. |
