Component Inspection
■ Check EMC
1.

IG KEY OFF.

2.

Disconnect EMC connector.

3.

Measure resistance between one and the other of EMC connector.

Specification : About 3.6 Ω (at 23°C)

4.

Is the measured value within specification ?

▶ Check TCCM connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known good EMC and check for proper operation.

If the problem is corrected, replace EMC and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика