4.
Keep the idle status and then confirm changing output value of "Oil temperature sensor".
Fig 1) Oil temperature sensor(normal status)
Connect scantool to data link connector(DLC).
Engine "ON".
Monitor the "Oil temperature sensor" parameter on the scantool.
Keep the idle status and then confirm changing output value of "Oil temperature sensor".
Fig 1) Oil temperature sensor(normal status)
Is "Oil temperature sensor" output value within normal range ?
 | ▶ Fault is intermittent caused by poor contact in the sensor's and/or TCM(PCM)'s connector or was repaired and TCM(PCM) memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Go to "Component Inspection" procedure. |
