Component Inspection
■ Check injector
1.

IG "OFF" and disconnect injector connector.

2.

Measure resistance between power and control terminals of injector connector.(Component side)

Specification : 14.5 ±~ 0.7Ω ( at 20℃/ 68℉)

3.

Is the measured resistance within specification ?

▶ Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known - good injector and check for proper operation. If the problem is corrected, replace injector and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика