Does the scantool show same DTC again ?
 | ▶ Substitute with a known-good Mechatronics (Valve-body + TCM) and check for proper operation. If the problem is corrected,replace Mechatronics (Valve-body + TCM) and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Fault is intermittent caused by poor contact in the sensor’s and/or PCM’s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure. |
How to perform Initial Learning
If you replace the automatic transmission or Mechatronics (Valve-body + TCM), or if you overwrite the TCU software, be sure to initialize the learned values and perform initial learning.
Step 1) Warm-up
Raise the ATF temperature by leaving the vehicle idling or performing city drive. Check the ATF temperature using the Scan-tool and make sure it is between 50°C( 122 °F) and 120°C( 248 °F). If the ATF temperature is outside this range, work to bring the range.
Don't raise the oil temperature by stalling the engine.
(Reference)
If the oil temperature is not between 50°C( 122 °F) and 120°C ( 248 °F), initial learning can not be performed. Before learning, check for variable speed shock or shift shock.
STEP 2) Driving learning
Select "D" range then depress accelerator pedal smoothly, and keep the APS value 17%, shift gear to 5th gear.
RKeep the vehicle speed over 60kM/h.
In condition that release the accelerator pedal and then depress the brake pedal narmally.Stop the vehicle then keep 5seconds.
STEP 3) Repeat this procedure 10 times.(Not necessary N-D,N-R Learning)
