1.
After loosening the mounting bolt, remove the handle cover (A).
After loosening the mounting bolt, remove the handle cover (A).
Remove the outside handle (A) by sliding it rearward.
Installation is the reverse of removal.
Make sure door lock operates and door open/closes properly.
Loosen the checker mounting bolts.
Detach the clips, remove the weatherstrip (A).
Installation is the reverse the removal.
Remove the door trim.
After loosening the mounting screw, remove the handle cover (A).
Installation is the reverse of removal.
Be careful not to scratch the door trim and other parts.
Put on gloves to protect your hands.
Remove the delta inner cover (A).
Remove the inside handle cover (A).
Loosen the door trim (A) mounting screws. Release the clips that hold the door trim.
Remove the inside handle cage (A).
Installation is the reverse of removal.
Make sure connectors are connected properly and each rod is connected securely.
Make sure the door lock and opens properly.
Put on gloves to protect your hands.
Remove the door trim.
Remove the glass mounting hole plug (B).
Remove the door belt weatherstrip.
Release the rear channel mounting bolt.
Be careful not to drop to glass and scratch the glass surface.
Carefully adjust the glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Installation is the reverse of removal.
Roll the glass up and down to see if it move freely without binding.
Adjust the glass position as needed.
Remove the door trim.
After disconnecting the connector (A), remove the power window motor (B).
Installation is the reverse of removal.
Grease should be applied to areas where there is of rotational parts and springs.
Roll the glass up and down to see if it move freely without binding.
Remove the following parts :
Door trim
Window glass
Outside handle
Loosen the mounting screw (A).
After loosening the door module mounting bolts, remove the door module (A).
Disconnect the connector (A).
Detach the clips, remove the wiring harness (B).
Installation is the reverse of removal.
Grease should be applied to areas where there is whole parts.
Make sure connectors are connected properly and each rod is connected securely.
Make sure the door lock and open properly.
Remove the following parts :
Door trim
Glass
Out side handle
Remove the module assembly.
Disconnect the latch connector, remove the latch assembly (A).
Installation is the reverse the removal.
Make sure door lock operates and open/closes properly.
Remove the following parts :
Door trim
Window glass
Door module
After loosening the mounting bolts, remove the door checker (A).
Installation is the reverse of removal.
Make sure the door opens properly and locks securely.
