2.
Push and hold the up switch.
A.
Until the slide moves forward 5.0 mm (after approx 15 seconds), the release the switch.
Check that the glass has been installed.
Finished height adjustment.
Push and hold the up switch.
Until the slide moves forward 5.0 mm (after approx 15 seconds), the release the switch.
After moving the slide 5mm forward, turn OFF the switch and push the UP switch (Keeping on pushing the switch with continuous operation)
If the motor initialization is successful, the sunroof should fully side open and close once.
When the sunroof is closed completely, turn OFF the UP switch initialize the motor completely.
After the motor is replaced and disconnected.
Initial value is erased or damaged because of short power electric discharge during operation
After using the manual handle.
Use the sunroof emergency handle.
To close or open the sunroof manually if the sunfoof cannot be closed electronically due to motor or controller electrical malfunction.
Operating method
Remove the overhead console
Push the emergency handle up into the hexagonal drive (A) of the sunroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
Carefully turn the emergency handle clockwise to close the sunroof.
After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle.
Do not use power tools to operate the sunroof.
Damage to the components may occur.
