1.
Remove both decoration cover (A).
Put on glove to protect your hands.
Remove both decoration cover (A).
Remove the glass (A) by lifting it up.
Do not damage the roof panel.
Installation is the reverse of removal.
Remove the over head console.
Confirm the position of guide whether it is closed or not when you remove the motor.
Disconnect the motor connector (A), remove the screws and then remove the motor (B).
Installation is the reverse of removal.
Make sure to initialize the motor.
Open the glass fully.
Disconnect the deflector link (A) from the frame (B), and then remove the deflector (C ).
Installation is the reverse of removal.
Remove the following parts :
Door scuff trim
Front pillar trim
Center pillar trim
Rear pillar trim
Headlining
Sunroof glass
Disconnect the drain tubes (C).
Remove the bracket (A).
After loosening the mounding bolts and nuts, remove the sunroof assembly (B).
Be careful not to scratch the interior trims and other parts.
Installation is the reverse of removal.
Remove the sunroof assembly.
Remove the cover (E).
Remove the drip link (A) and sunshade stopper (B).
Remove the sunshade (C) and drip rail (D).
Installation is the reverse of removal.
Remove the sunroof assembly.
Lower and slide the guide assembly (A) to the rear to remove.
Remove the guide (A) and slide (B).
Installation is the reverse of removal.
Make sure to align the slide with the center of“A” and “B”.
Make sure to initialize the motor.
