13499204

1.

Drain the power steering fluid.

2.

Remove the both front wheels.

3.

Remove the tie rod end ball joint (C) from the knuckle by using the SST (09568-4A000).

(1)

Remove the split pin (A).

(2)

Remove the castle nut (B).

(3)

Use the SST (09568-4A000).

Tightening torque :

58.8~78.4N.m (6.0~8.0Kgf.m, 43.3~57.8lb.ft)

caution

●

When using SST, be sure not to damage the dust cover of lower arm ball joint.

●

Keep SST tied to the car because there is a risk of injury by dropping the SST during removing the lower arm ball joint.

●

The peripheral parts may be damaged when removing the lower arm ball joint with a general tool such as lever, so be sure to use SST.

4.

Loosen the tube bracket bolts and then disconnect the pressure (B) and return tube (A).

5.

Remove the steering gear box (A) by loosening the bolts and nuts.

6.

Installation is the reverse of the removal.

note

●

Fill the reservoir with the power steering fluid and then bleed the power steering system.

●

Inspect the front wheel alignment and adjust it if necessary.