1.
Insert the four oil seal (A).
caution
Must use new ones when reassembled.
Insert the four oil seal (A).
Must use new ones when reassembled.
Install the spring and rachet (A) by inserting the guide pin.
Install the guide plate (A) by installing the special bolts (10ea) with TORX wrench(T27).
Install the selector shaft (A), detent disk (B), and connecting rod (C) by installing the holding pin.
Install the adapter (A).
Must use new ones when reassembled.
Install the mechatronic (A) by installing the special bolts (10ea) with TORX wrench(T40).
Be careful not to drop or damage to the mechtronik.
After installing the connector housing (B), push the white clip (A) downward.
Install the plastic oil pan (A) by installing the special bolts (20ea) with TORX wrench(T40).
Be careful not to drop or damage to the plastic oil pan.
Refill the ATF. (refer to Procedure Of ATF Level Adjustment)
