1.
Install the mounting bolts(A,B-4ea) and the transfer assembly.
Install the mounting bolts(A,B-4ea) and the transfer assembly.
Lowering the vehicle or lifting up a jack, install the transmission assembly.
Be careful not to damage tubes, hoses or wire.
Connect the CKP sensor(A).
Install the mounting bolts (A-4ea) on the transmission side.
Install the mounting bolts (A-2ea).
Install the mounting bolts (A-2ea) for the starter motor.
Install the transmission lower mounting bolts(A).
Install the torque converter mounting bolts (A-6ea) by rotating the crank shaft.
Tightening torque :
34.3~41.1Nm (3.5~4.2kgf.m, 25.3~30.3lb-ft)
Install the drive plate cover(A).
Install the under cover bolts(A-10).
Install the oil cooler pipes(A).
Connect the transmission wire harness connectors(A)
Connect the 4WD ECU connector(A) or EMC connector(B).
Connect the shift cable assembly (B) by tightening the nut (A-3ea)
Install the rear propeller shaft(A).
Tightening torque :
58.83~68.64Nm(6~7kgf.m, 43.39~50.63lb-ft)
Install the insulator support bracket(A).
Install the cross member(A)
Install the front propeller shaft(A). (4WD)
Tightening torque :
58.83~68.64Nm(6~7kgf.m, 43.39~50.63lb-ft)
Install the exhaust manifold stay bolt (A).
Install the front muffler(A) or muffer hanger rubber(B), by removing rear muffler(C).
Connect the oxygen sensor(A) connector.
Support the transaxle with a jack
Be careful not to give a shock or damage to the plastic oil pan.
Install the battery (-) terminal.
Refill the transmission fluid.(See 'service adjustment procedure')
