2.
Disconnect the ECM connector (A).
After replacing ECM, MUST input the injector specific data (7 digits) of each cylinder into a new ECM with scan tool.
In the case of the vehicle equipped with immobilizer, perform "KEY TEACHING" procedure together (Refer to "IMMOBILIZER" in BE group).
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the ECM connector (A).
Unscrew the ECM bracket mounting bolts and then remove the ECM (B).
Install a new ECM.
ECM installation bolts (on bracket):
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
ECM bracket installation bolts/nuts:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
Perform "Injector Specific Data Input" procedure (Refer to "INJECTOR" in this group).
Perform "Key Teaching" procedure (Refer to "IMMOBILIZER" in BE group).
