Replacement
1.

Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.

Disconnect the water sensor connector (A), the heater connector (B), and the thermostat connector (C).

3.

Disconnect the fuel inlet tube quick-connector (D) and the fuel outlet tube quick-connector (E).

4.

Unscrew the fuel filter bracket installation bolt/nuts (F) and then remove the fuel filter from the vehicle.

5.

Remove the fuel filter assembly from the bracket after removing the bolt (A).

6.

Remove the water sensor (A).

7.

Remove the fuel filter (A) with a wrench from the fuel filter assembly, after then replace it with a new one, and then install the fuel filter assembly in accordance with reverse of above steps.

caution

When replacing the fuel filter, must replace the O-ring.

8.

Start the engine and check that there is any leak on the low pressure fuel circuit including the fuel filter.

Яндекс.Метрика