1.
Install the operating lever assembly (E).
Install the operating lever assembly (E).
Install the upper return spring (C) and the brake shoes (D).
Install the adjuster assembly (B) and the lower return spring (A).
Install the shoe hold down pin (A) and spring (B) by pressing and rotating the spring.
Install the parking brake cable (B), then install the clip (A).
Install the rear brake disc, then adjust the rear brake shoe clearance.
Remove the plug from the disc.
Rotate the toothed wheel of adjuster by a screw driver until the disc is not moving, and then return it by 5 notches in the opposite direction.
Install the brake caliper assembly. (Refer to "Rear brake installation")
Install the tire and wheel.
If the parking brake shoe or the brake disc are replaced a newly one, perform the brake shoe bed-in procedure.
While operating the parking brake pedal for 98N (10kgf, 22 lbf) effort, drive the vehicle 500 meters (0.31 miles) at the speed of 60kph (37.3 mph).
Repeat the above procedure more than two times.
Must be held on at 30% uphill.
After adjusting parking brake, notice following matter;
Must be free from troubles when the parking pedal is operated at 981 N (100 kgf, 220 lbf).
Check that all parts move smoothly.
The parking brake indicator lamp must be on after the parking pedal is worked and must be off after the pedal is released.
Install the parking brake cable (A).
Install the fixing clip (C) and the cable adjusting nut (B) after fixing the parking brake cable.
Install the parking brake pedal, and then install the parking brake pedal mounting bolts and nut.
Adjust the parking brake pedal stroke by turning the adjusting nut (B).
Adjust the adjusting nut (B) so that parking brake pedal stroke is to be between 3~4notches when operating effort is 196 N (20 kg.f, 44 lb) after full stroke operation of parking brake pedal over 3 times for setting parking wire.
Adjust cable stroke with the equalizer adjusting nut (D) inside floor console if the cable adjusting nut (B) can’t be used because of insufficiency of an adjusting section of the front cable.
The parking brake adjustment must be carried out after adjusting the rear shoe.
After adjusting parking brake, notice following matter.
Must be free from clearance between adjusting nut and pin.
Check securely that the brake is not dragging.
Reconnect the parking brake switch connector(A).
Install the IPM. (Refer to the Body Electrical System group - BCM)
Install the crash pad lower panel. (Refer to Body group - Crash pad)
Install the floor console. (Refer to Body group - Console).
