3.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting nuts.
Tightening torque
: 5.9 ~ 6.9 Nm (0.6 ~ 0.7 kgf.m, 4.3 ~ 5.1 lb.ft)
Remove the ignition key from the vehicle.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting nuts.
Tightening torque
: 5.9 ~ 6.9 Nm (0.6 ~ 0.7 kgf.m, 4.3 ~ 5.1 lb.ft)
Install the heater duct to the crash pad.
Install the crash pad. (Refer to the Body group- crash pad)
Tighten the passenger airbag mounting bolt.
Tightening torque
: 18.6 ~ 26.5 Nm (1.9 ~ 2.7 kgf.m, 13.7 ~ 19.2 lb.ft)
Connect the passenger airbag harness connector to the SRS main harness connector.
Install the glove box. (Refer to the Body group- crash pad)
Reconnect the battery negative cable.
After installing the passenger airbag (PAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
