2.
IG "ON" and monitor the "PRESSURE SENSOR" parameter on the scantool.
Specifications : The sensor output's normal range : 0.1 ~ 4.85 V
Fig 1) Normal data at the IG "ON"
Connect scantool to Data Link Connector(DLC).
IG "ON" and monitor the "PRESSURE SENSOR" parameter on the scantool.
Specifications : The sensor output's normal range : 0.1 ~ 4.85 V
Fig 1) Normal data at the IG "ON"
Is the output of the pressure sensor normal?
 | ▶ Fault is intermittent caused by poor connection in ALS ECU's connector or was repaired and ALS ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. ▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Terminal and Connector Inspection" procedure. |
