Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Right Taillamp Circuit Inspection" procedure.

IG "OFF", disconnect battery (-) terminal.

Disconnect RAM, right taillamp connector.

Measure resistance between the Right Taillamp terminal of RAM harness connector and ground of the Right Headlamp High.

Is the measured resistance within specification?

	▶ Substitute with a known - good FAM and check for proper operation. If the problem is corrected, replace the FAM and go to "Verification of Vehicle Repair" procedure.
	▶ Repair open in circuit of Right Headlamp High or Left Headlamp High internal open, and go to "Verification of Vehicle Repair" procedure.