Installation is in the reverse order of removal.
Perform the followings :
Adjust a shift cable.
Refill engine with engine oil.
Refill a transaxle with fluid.
Refill a radiator and a reservoir tank with engine coolant.
Place a heater control knob on "HOT" positon.
Bleed air from the cooling system.
- Start engine and let it run until it warms up. (until the radiator fan operates 3 or 4 times.) - Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system. - Put radiator cap on tightly, then run the engine again and check for leaks. |
Clean battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent corrosion.
Inspect for fuel leakage.
- After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes. - Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line. |
