If operating lock/unlock the Power Door Lock SW,which signal goes to DDM at first and its signal goes to ADM, RAM through the CAN communication. ADM controls Door Lock Actuator with this signal.
ADM sets DTC when ADM detects open circuit in Assist Door Unlock Actuator.
Item | Detecting Condition | Possible Cause |
DTC Strategy |
•
Open circuit in Assist Door Unlock Actuator |
•
Open circuit in Assist Door Unlock Actuator
•
Open circuit in Assist Door Unlock Actuator Coil |
Enable Conditions |
•
Not in START position with IGN Key
•
200mS after START position with IGN Key
•
Motor works on | |
Threshold Value |
•
Current is lower than 150mA | |
Diagnostic Time |
•
Immediately (DTC status memorized) | |
DTC Erasing Time |
•
DTC is erased immediately after trouble fixed (In case of the past error, perform DTC erasing procedure.)
•
Disconnecting battery cable |
