Component Inspection
■ Open or Short Check
1.

Ignition "ON" & Engine "OFF".

2.

Measure voltage between signal terminal of the G sensor harness connector and chassis ground.

Specification : Approx. 2.5V

note
To view Flash content, you need to install the appropriate browser extension
3.

Is the measured value within specifications?

▶ Fault is intermittent caused by poor connection in G sensor harness and/or HECU's connector.

Go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good G sensor and check for proper operation.

If problem is corrected, replace G sensor and then go to "Verification of Vehicle Repair" procedure.

※ In a case of replacing the G sensor, operate "Steering Angle Sensor Calibration" by scantool.

Яндекс.Метрика