Component Inspection
■ Check injector resistance
1.

IG key OFF.

2.

Disconnect injector connector.

3.

Check resistance between 'High' terminal and 'Low' terminal of 'INJECTOR' connector. (Injector component side)

Specification : 150 ~250 kΩ (20℃)

4.

Is the measured value within specification?

▶ Go to "Verification of Vehicle Repair" procedure.

▶ Replaces injector, and go to "Verification of Vehicle Repair" procedure.

note

Replacing injectors, peculiar IQA code of each injector should be inputted to ECM. Perform this process using "INJECTOR CORRECTION" function on GDS.

Яндекс.Метрика